Connect the corresponding output polarity of the welder output wiring (tighten the nut when the output wire is connected to the output pole). When working, clamp the workpiece with the clip on the output black line, close to the tungsten needle, depending on the size and shape of the workpiece, generally tungsten needle and The distance between the workpieces is between 0.5 and 1 mm. After the welding position is fixed, the foot switch is jogged and a high temperature arc is generated between the workpiece and the tungsten needle. The workpiece is welded in an instant. The discharge end of the tungsten needle is used before and The process must be kept sharp so that it stays well Electrical state.
Welding can change the output pulse current according to the size of the workpiece, the size of the solder joints, and the process requirements to achieve the desired effect (the machine can weld 0.5-2.5MM). When the potentiometer is rotated clockwise (coarse adjustment, fine adjustment), the output pulse current increases, and the output pulse current decreases. If the place where the welder is placed is wet or not used for a long time, it will be damp. If it is found that the above phenomenon should be dried after use, the machine should be well grounded. Please pay attention to safety when using.
We will track the item all the time until it is reached to you. Return accepted in 30 days after the item reached to you. Return package must be in the original packaging, everything must be in new condition. A good feedback is very important.
We will work with you to solve any problems. If you have a question or concern before or after receiving your item, please do not hesitate to contact our customer service team by clicking on the "Ask a question" link in the bottom left.